Nissan-Navara.net banner
1 - 5 of 5 Posts

·
Registered
Joined
·
113 Posts
Discussion Starter · #1 ·
Hello,

After I changed my clutch in february at -19C I felt the pedal going up slowly but this happened only when very cold and other thing sometimes when changing gears going for 5th gear I would land in 3rd when changing gears fast, when I switch normally it changes gears ok. Should I change the slave clutch cylinder ? Is it ok to just change out the slave cylinder and in couple of moths also change the clutch master cylinder ? As a side note after I changed the clutch and flywheel pedal became more soft and bite point got a bit lower but still like halfway it catches at like 65-70% of pedal travel, is this coming from the clutch master ?
 

·
Administrator
Joined
·
15,137 Posts
I would bleed it first to see if that is the problem.
If no better, the slave is fairly cheap, so change that.
Hopefully the master is fine.
 

·
Registered
Joined
·
113 Posts
Discussion Starter · #4 ·
I just ordered the master and slave cylinder but wanted to know if there are other washers that should be changed when they change the parts.
 
1 - 5 of 5 Posts
Top