Nissan-Navara.net banner

1 - 7 of 7 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Hey everyone
I have a 2008 d22 yd25ddti,
Over the weekend replaced my scv due to idle issue, which fixed the problem.
But after replacing the scv, the d22 has now started bring up a p0089 fault code and going into limp home mode, but if you turn it off then on it's it runs fine.
Any ideas would be greatly appreciated
 

·
Registered
Joined
·
5 Posts
Discussion Starter #5
I've pulled it out and checked, it was fine. Even tried rotating it 180°, still no difference. Only seem to be happening at idle when it's cold. If the high idle switch is on from start up it runs fine and won't go into limp mode.
 

·
Registered
Joined
·
5 Posts
Discussion Starter #7
Just tried that last night, no difference this morning, I'm starting to think the timing chain might be at fault, has a good rattle on start up. And won't fault once it hits 60 degrees Celsius in till it's cooled down completely.
 
1 - 7 of 7 Posts
Top