Nissan-Navara.net banner

1 - 8 of 8 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter #1
hi guys

i have just purchased some 17" steel wheels from jimny bits
i am unsure about what stud nuts to use to fit them. can anyone advise ? do theyt have to be tapered? if so what angle
thanks
Andy
 

·
Administrator
Joined
·
12,668 Posts
Yes, use the same nuts as the alloy wheels. There is only one taper, can't remember what it is though.
 

·
Registered
Joined
·
34 Posts
Discussion Starter #5
i dont know :( but i will check tommorow. the nuts are open ended , they seem to go all the way down to the wheel
 

·
Administrator
Joined
·
12,668 Posts
I didn't read your post carefully enough, the old wheel nuts don;t screw on far enough... so provided the new ones tighten properly you will be fine.
 

·
Registered
Joined
·
34 Posts
Discussion Starter #7
hi landmann. i fitted the wheels and new tyre . but notticeced im getting a howling noise about 20mph up, any ideas , the tyres arnt fowling anything
64033
 
1 - 8 of 8 Posts
Top