[jpg27]

Chris

techniclutch is same place I got mine from

You are right they only go on one way.

The teeth are close enough to original to get it to run but not close enough to get correct signal.

Are you still having problem go back to the and request a replacement flywheel

Only other thing to check is the crank shaft sensor itself

Hope this helps mate

John

 

[jpg27]

Hi Chris

Did you check the crank shaft sensor pick up ont he new solid flywheel

I just swapped mine over last week and the replacement flywheel was slightly diffrent onthe tooth size went to limp mode also.

Contacted company that supplied clutch and flywheel got replacement flywheel and all OK now

Where did you get the clutch and flywheel from ?

John