[nuts4tools]

Hi all I have a 2010 YD25 D40 Automatic 2WD vehicle the water coolant supply pipe developed a pin hole & boiled the engine quicker than candy floss in hot water. I've now managed to find a 2011 YD25 motor from a 2WD 6 speed manual. Can anyone tell me if there will be any problems with swapping them out. I've asked the Nissan dealership, & several independent repairers, & no one can give me a definitive answer, oh & they are both Taiwanese built. As it's my only vehicle so I need an answer pretty quickly before I end up walking

 

[landmannnn]

Hi all I have a 2010 YD25 D40 Automatic 2WD vehicle the water coolant supply pipe developed a pin hole & boiled the engine quicker than candy floss in hot water. I've now managed to find a 2011 YD25 motor from a 2WD 6 speed manual. Can anyone tell me if there will be any problems with swapping them out. I've asked the Nissan dealership, & several independent repairers, & no one can give me a definitive answer, oh & they are both Taiwanese built. As it's my only vehicle so I need an answer pretty quickly before I end up walking

I can't give you a definitive answer, sorry.

Maybe somebody else can?

You might also try The Navara forum.

Not that this helps much, once did that with a different vehicle and the spigot bush on the end of the crank was different, so possibly not